TOORX ERX700, Инструкция

Страница: 6 / 31

ASSEMBLY INSTRUCTIONS
1
MAST ASSEMBLY
1. Locate the Console Mast (10) and Console Mast Cover (50) and slide the Cover
onto the Mast as far as it will go. Make sure the Console Mast Cover (50) is facing
the correct way.
2. At the top opening of the Main Frame (1) of the elliptical is a Computer Cable (37).
Unravel and straighten out the Computer Cable (37) and feed it into the bottom of
the console mast tube (10) and out of the top opening.
3. Install the Console Mast (10) into the receiving bracket in the top of the Main
Frame (1).
Put the 4pcs of 5/16"x 23 x1.5T Flat Washers (125) onto the 4pcs of 5/16" x 15m/m
Hex Head Bolts (88) and the 2pcs of 5/16” x 23 x 2T Curved Washers (129) onto
the 2pcs of 5/16" x 15m/m Hex Head Bolts (88). Install, and hand tighten by using
the 12m/m Wrench (136).
NOTE: There is a electrical wire running through the Console Mast Tube (10). Be
careful not to damage or pinch this Computer Cable (37) during this procedure.
4. Cut off the wire tie and separate the Computer Cable (37) then plug it in together
with two Handpulse W/Cable Assemblies (41) onto the bottom of Console
Assembly (36). Secure the Console Assembly (36) on the console holding plate
with 4pcs of M5x10m/m Phillips Head Screws (98) by tightening them with
Combination M5 Allen Wrench & Phillips Head Screw Driver (135).
5. Insert two Rail Tubes (17) into the Frame Base and secure with 2pcs of 3/8" × 2-
1/4"_Button Head Socket Bolts (97), 2pcs of 3/8" × 19 × 1.5T_Flat Washers (123)
and 2pcs of 3/8" × 7T_Nyloc Nuts (115) by using 13.14m/m_Wrench (137) and
Combination M5 Allen Wrench & Phillips Head Screw Driver (135).
6. Lay Rail Assembly (13) between Rail Tubes(17), and secure with 4pcs of 3/8" × 2-
1/4"_Button Head Socket Bolts (97) and 4pcs of 3/8" × 23 × 2T Curved Washers
(130) by using Combination M5 Allen Wrench & Phillips Head Screw Driver (135).
6