TOONG IN ELECTRONIC CORP.
Copyright © 2005. All rights reserved
8
TX / HCI dongle
-
As a TX dongle, you should turn off the device and charge it through
USB jack. It the battery is low, the red LED will start flashing.
-
As a HCI dongle, you didn’t need charge it because power comes
from PC.
*Note: 1. If the power is low, the Red LED indicator of headset will start to
flash.
2. When charging is completed, the red LED indicator will be off.
Responding to Cell Phone
1. Setting Up
Before you turn on the headset, please use the USB charging cable to charge
them.
2. Pairing
(1) Turn on the Bluetooth enabled cell phone.
(2) Turn on the headset.
(3) Operate the Bluetooth enabled cell phone to search headset
Note: Users need to keep the two devices between 2 meters in case of
connection failure. The Blue LED indicator of headset will be constantly
on during search.
(4) Enter PIN code “0000” when the pop-up screen is shown on the cell
phone.
(5) Pairing is done while the status LED indicator start flashing.
3.Connecting
(1) ”Pairing” creates a link between Bluetooth enabled cell phone and Stereo
Headset. It allows the phone to remember the headset’s unique Bluetooth
ID. You could add it to a list of “Paired Device” in the phone.
(2) The headset only needs to be paired ONE time with the phone before
use.
(3) Once the headset is paired, it can be easily connected to the phone.
(4) If the pairing information or log were deleted from the phone, the headset
must be paired with the phone again.
(5) Start to use Stereo Headset to pick up / drop calls in a wireless mode.
