TOOLSPACE XW-1201, Руководство пользователя

Страница: 17 / 20

The charger was designed to charge battery pack between 0°C and 50°C. If
the battery pack is too cold or too hot, the charger will not charge. Allow the battery
to warm up or cool down.
CHARGING PROCEDURE
Plug the charger
4 )
into the power supply and on the other side to the connector of
the cordless screwdriver cord
)
The charging time takes about 3-5 hours.
ASSEMBLY AND REPLACEMENT OF DRILLS / SCREWDRIVER BITS
1. Hold the rear sleeve of the keyless chuck tight and turn the front sleeve in a counterclockwise
direction (see markings on the chuck - arrow Release), until the tool can be inserted
5)
2. Insert the designated drill into the drill chuck opening as far as it will go. Clamp the tool
centrally in the chuck!
3. Hold the rear sleeve of the keyless chuck tight and turn the front sleeve in a clockwise
direction (see markings on the chuck - arrow Grip) until the chuck tight.
4. Make sure that the drill correctly into the drill chuck. Loosen drills might cause accidents!
5. Conduct a short test-run and make sure that the drill sits tightly even after a complete run.
6. Removing the drill - hold the rear sleeve of the keyless chuck tight and turn the front sleeve
in a counterclockwise direction (see markings on the chuck - arrow Release)
5)
SCREW BITS
• Make sure that the bit and screws you‘re using match in shape and size.
• Do not use damaged bits.
DRILLS
Every work piece and material needs to be drilled with its designated drill. Select a suitable drill bit.
Please inform yourself before drilling, otherwise you might cause damages on the tool.
When choosing the size of the drill bit observe the maximum dimensions sp
in the .
OPERATION
TORQUE SETTING
CAUTION!
Please make sure that it is only set when the power tool is turned off.
• The cordless screwdriver is equipped with a coupling that allows you to adjust the tightening
torque according to the type of material and screw diameter.
• The fastening torque can be adjusted by turning the adjusting ring
6)
so that its
graduations are aligned with the arrow on the tool body.
• Low values are designed for small screws and soft materials. High values are designed for
large screws and hard materials.
• Adjust the torque as necessary.
1 - 6 for driving small screws