@ToolkitRC 2021
16
3，SBUS signal output
From the PWM output page, short press on PWM to
change the output type; scroll right until SBUS is
displayed. Short press to confirm the SBUS selection, as
shown below:
In the SBUS output page, press down on the roller for 2
seconds to set the output value of each channel.
===================================
1，When the cycle is set to less than 2ms, the
maximum width will not exceed the cycle value.
2，The channel output slider is safety protected. There
will be no signal output until the slider is
returned to its minimum position first.
===================================
