Allow twigs and small branches up to 3” in diameter to be fed into the
impeller for chipping.
Tamper Plug
This plug is inserted into the chipper chute to push twigs and small
branches towards the impeller blades without endangering your hands.
Gear Adjust Handle
Put the handle in the forward gear position 1or 2, the machine will go
forward. Put the handle in the backward gear position 1 or 2, the
machine will go backward.
SeeFigure 5
.
Figure 5
Vacuum Bag
Collects shredded or chipped material fed through the chipper chute or
vacuumed up through the nozzle.
Drive control
The drive control is located on the upper handle assembly. Squeezing the
drive control against the upper handle engages the rear wheels. Release
the drive control to slow down or step wheel drive. See Figure 6.
Figure 6
Starter Handle
It is used to stop the engine or stop the machine immediately.
Throttle Control
Upper position is to speed up the engine, lower position is to slow down
the engine.
Throttle Control Lever
The throttle control lever is located on the engine. It controls the
