TONI TMS210F, Инструкция пользователя

Страница: 13 / 19

Fig.7
2
1
Fig.8
Work table
Mitre indicator
Mitre scale
WARNING:
If inner blade flange has been removed, replace it before placing blade on spindle.
Failure to do so could cause an accident since blade will not tighten properly.
WARNING:
Always install the blade with the blade teeth and the arrow printed on the side of the
blade pointing down at the front of the saw. The direction of blade rotation is also stamped with an
arrow on the upper blade guard.
8.
Replace outer blade flange. The double "D" flats on the blade flanges align with the flats on the
spindle.
9. Depress spindle lock button and replace hex bolt. NOTE : The hex bolt has left hand threads.
Turn blade bolt counterclockwise to tighten.
10. Tighten hex bolt securely.
WARNING:
Make sure the spindle lock button is not engaged before reconnecting saw into
power source. Never engage spindle lock button when blade is rotating.
ADJUSTING THE BEVEL ANGLE
1.
Loose the bevel angle locking knob (1) by turning it counter clockwise to allow the cutting head (2)
to rotate (Fig. 7). When rotate to intended angle, tighten the locking knob(1).
ADJUSTING THE MITRE ANGLE (see figure 8)
The mitre saw can be cutting as mitre angle -45
°
to 0
°
to +45
°
, and the mitre angle have not a locking
device, you can move the cutting head left or right to rotate the work table to set the cutting mitre
angle.
ASSEMBLY AND INSTALLATION
!
!
!
13