TONI TMS210F, Инструкция пользователя

Страница: 10 / 19

!
Fi 2
safety equipment, such as those dust masks that are specially designed to filter out microscopic
particles.
WARNING:
Never look directly into the laser beam. Direct exposure to your eyes could
cause blindness.
CUTTING HEAD LOCK-DOWN (
See Figure 1 )
This mitre saw is shipped with the cutting head locked in the DOWN position. The lock-down system
must be used when moving, transporting or lifting the mitre saw to prevent the cutting head from
shifting. It also makes lifting the mitre saw easier and safer.
WARNING:
Never turn the mitre saw ON when the cutting head is locked in the DOWN position.
Always unlock the lock-down pin and allow the cutting head to rise to its maximum height before
turning the mitre saw ON.
To unlock the lock-down pin:
1.
Use your left hand to slightly push downward on the main handle.
2. While holding the main handle down, use your right hand to pull the lock-down knob (1) outward.
3. Lift your left hand and allow the cutting head to rise to its maximum height.
To lock the cutting head in the DOWN position, push the lock-down knob(1) inward until the knob is
insert the hole (2).
DUST BAG (
See Figure 2.)
A dust bag is provided for use on this miter saw. It fits over the dust guide on the upper blade guard.
To install it, squeeze the two metal clips to open the mouth of the bag and slide it on the dust guide.
Release the clips. The metal ring in the bag should lock in between the grooves on the dust guide.
To remove the dust bag for emptying, simply reverse the above procedure.
ASSEMBLY AND INSTALLATION
!
Fig. 1
1
2
2
1
10