Tomey TCP-2000P, Руководство по эксплуатации

Страница: 43 / 113

Operation Manual
43
designed to enable interpretability of TCP-2000P with devices purchased from
different vendors.
Colour can be adjusted for phoropter and colour test filters or glasses
independently. To adjust colour to test filters/glasses
Phoropter option should be
disabled, please refer to chapter 4.10 . To adjust panel colours to the phoropter,
Phoropter option should be enabled.
TCP-2000P allows setting colours to any required colour by modification of
red/green/blue compound.
R - RED G – GREEN B - BLUE

Colour modification effect is visible on two square
polygons displayed in bottom right corner of the screen.

It is recommended to adjust only RED compound value for
the red polygon (colour mask) and only GREEN compound
for the green polygon.

Depending on Phoropter setting in the configuration menu
you are adjusting panel colours for phoropter or colour
glasses only.
To adjust colour intensity to the required level select with Arrow up/down button
required colour compound, then press right Arrow to begin edition of the intensity.
To modify colour value use up and down Arrow button. To accept and store the
value press Arrow left.
4.14. Exiting Menu
Select ‘ Exit (SETUP) ’ using Arrow Up or Arrow Down button.
1. Press Right Arrow to exit Service Menu. TCP-2000P will return to the
last displayed test. Changes implemented will be saved after Chart Panel
is turned off.
2. You can exit Service mode by simply pressing ‘ SETUP’ button. TCP-
2000P will return to the last displayed test. Changes implemented will be
saved after Chart Panel is turned off.
3. You can also exit from MENU using ‘ ESC’ button. In this case changes
implemented will be saved only until Chart Panel is turned off.
Each time you would like to return to higher level of Configuration Menu please
select „
Exit (SETUP) ” and press the right Arrow or at any time SETUP button.
WARNING !