Tomey TCP-2000P, Руководство по эксплуатации

Страница: 31 / 113

Operation Manual
31
When executing the program, you can get access to additional
options for given chart , as those available in normal operating
mode, as described below.
4. Press OK button - in the right bottom of the screen a red letter A is
displayed.
4.1 Now you can use arrows, masks, ok, and +/- buttons as in normal
operating mode for given chart.
4.2 To exit sub-mode to continue executing user's program press ESC button.
4.12. Auto-Off
This function allows user to preset time after which Chart Panel enters stand-by
mode. You can set this time from 4 to 10 minutes.
1. Enter ‘
Auto-Off
’ using Arrow Up or Arrow Down button.
2. Press Right Arrow to edit time for automatic auto off.
3. Use Up and Down Arrows to set required time.
4. To store selected value press Left Arrow.
Power OFF – new power saving feature.
TCP-2000P Chart Panel will turn itself off when not used after preset time. This
time is set in factory to 4 hours. Service personnel can adjust it during installation
to 30min, 1h, 2h, 3h, 4h or 8h, or turn this feature off completely, depending on the
customer needs. If TCP-2000P is in off-mode LED on the front panel is also off.
To restart TCP-2000P simply press any key on the remote control. Time needed
for startup is approximately 45sec.
4.13. Service mode (Service)
1. Select ‘ Service ‘ , using Arrow up or Arrow down button.
2. Press right Arrow. Message ‘Enter Access Code’ will be displayed.
From the remote control type following sequence:
NOTE !
NOTE!