Operation Manual
22
3.5. Changing remote control channel.
When two or more units of the TCP-2000P systems are used in the same room, a
device failure may occur due to interference if the same remote control channels
are used. In such case, set different channels for each remote control. There are 3
remote control channels available.
The communication channel must be set at the same time for both the remote
and the chart panel.
To change remote control channel please direct remote control toward main unit
and press and hold simultaneously following 3 buttons.
PRG + SLEEP/OFF + F1 to select channel no 1.
PRG + SLEEP/OFF + F2 to select channel no 2.
PRG + SLEEP/OFF + F3 to select channel no 3.
Please keep button pressed until main unit will confirm channel change with
two beeps.
Removing batteries from remote control will reset its current
channel setting. It will be automatically set to channel no 1. If
different channel was used before please perform channel
selection procedure. Otherwise main unit will not respond to
remote control commands.
Remote control channel is immediately changed when three
buttons are pressed at one time. Main unit will change its
channel only if you keep those buttons until you get two beeps
conformation.
Channel 1 is Default factory setting.
WARNING !
WARNING !
WARNING !
Содержание TCP-2000P
