tomado TWM9001W, Инструкция по эксплуатации

Страница: 37 / 104

EN - 37
LEVELLING THE APPLIANCE
WARNING!
• The lock nuts on all four feet must be screwed tightly against the housing to ensure the appliance stands steady on its feet.
Use a level and a spanner to level the appliance.
1. Loosen the lock nut with a spanner.
2. Turn the foot until it reaches the floor.
3. Level the appliance in longitudinal and traverse direction by rotating the adjustable feet.
4. After adjusting the feet, firmly tighten the lock nuts with a spanner against the housing.
CONNECTING THE WATER SUPPLY HOSE
WARNING!
To prevent leakage or water damage, follow the instructions in this chapter.
• Make sure not to kink, crush or modify the water supply hose.
i
Tighten the water supply hose by hand, firmly enough for the hose to have
a good seal. After connecting the hose, the seal must be checked for any leaks.
Do not use pliers or similar tools when connecting the water supply hose as this
could damage the nut thread.
1. Connect the water supply hose to the water inlet valve on the back of
the appliance.
2. Connect the other end of the water supply hose with the aqua stop to
a water tap with cold water.
CONNECTING THE WATER DISCHARGE HOSE
WARNING!
• Make sure not to kink or protract the water discharge hose.
• Connect the water discharge hose properly, otherwise it could result in damage of water leakage.
Feed the water discharge hose into a drain pipe, wash basin or floor drain. Be careful not to feed the water discharge hose
to deep in the drain. Otherwise the waste water can not flow freely. The vertical distance from the floor to the end of the
discharge hose may no more be than 100 cm and no less than 60 cm.
1. Put the water discharge hose in a floor drain. 2. Connect the water discharge hose to a drain pipe.
Max. 100 cm Min. 60 cm
floor drain
Max. 100 cm Max. 100 cm Min. 60 cm