EN - 38
CONNECTING THE APPLIANCE TO THE POWER MAINS
WARNING!
• Before connecting the appliance to the power mains, wait for at least 2 hours until it reaches room temperature.
• Connect the appliance to a grounded power outlet. After installation, the wall outlet must be freely accesible.
The outlet must be fitted with an earth contact (in compliance with the relevant regulations).
• Information on your appliance is indicated on the rating plate.
WARNING!
• Using an over-voltage protection to protect the appliance in case of a lighting strike, is recommended.
WARNING!
•Donotconnecttheappliancetothepowermainsusinganextensioncord.
i
• Do not connect the appliance to an electrical outlet intended for an electric shaver or hair dryer.
• Any repair and maintenance pertaining to safety or performance must be done by trained experts.
• A damaged power cord may only be replaced by a person authorized by the manufacturer.
OPERATION
• QUICK START
i
CAUTION!
• Before washing, please make sure the appliance is properly installed.
• Your appliance was thoroughly checked before it left the factory. To remove any residual water and to neutralize potential
odors, it’s recommended to clean your appliance before the first use. To do so, please run the Cotton programme at 90°C
without laundry and detergent. See the chapter
WASHING
.
i
CALIBRATING THE APPLIANCE!
It’s recommended to calibrate the appliance before using it, so that it provides the best performance.
The appliance is able to detect the amount of laundry that is loaded in the drum. This function will optimize the appliance’s
performance by minimizing energy and water consumption, saving you money and time.
Therefore it’s recommended to calibrate the appliance for the best use.
1. Remove all accessories from the drum and close the door.
2. Insert the mains plug to the power outlet.
3. Switch on the appliance to any programme and press TPM and START DELAY simultaneously for 3 seconds until [t19]
is displayed.
4. Press
to start the appliance. The drum will spin in order to calibrate it.
5. Wait till the drum stops spinning and a [ random number ] is displayed.
Содержание TWM9001W
Страница 103: ...103 ...