Toledo Brake Monitor, Инструкция по установке и эксплуатации

Страница: 18 / 29

Doc #0017289 Brake Monitor Operator Manual Page 15
SECTION 7
SYSTEM SETUP
7.1 SET PRESS ANGLE
After selecting Set Press Angle from the System Setup Menu, the above screen will be
displayed.
Steps to set the Press Angle:
1) Inch the press around and make sure that the PRESS ANGLE is moving in the
correct direction. If it is not, switch the A and B Encoder wires.
2) Inch the press around at least one full stroke to make sure that the Z pulse has
cycled
3) Inch the press to a known position (the most common is either 0 or 180).
4) When the press is at a known position, use the numeric keys to type in the Angle
offset (0-359). The offset can be calculated by determining the number of degrees
the displayed angle is from the actual angle of the press.
5) When the correct offset is displayed, press the <ENTER> key.