Toledo Transducers MoniTTor N269, Инструкция по установке и эксплуатации

Страница: 6 / 53

2
G. Other Information……………………………………………………………………...………Page 27
1. The Last Alarm
Page 27
2. The Last High Alarm Page 27
3. The Last Low Alarm Page 28
4. The Highest Load Page 28
5. The Lowest Load Page 28
6. The Production Rate in Strokes per Minute Page 28
7. The Down-time (Time since the Last Stroke) Page 29
8. The Diagnostics Page 29
III. Installation Page 30
A. Mounting the Enclosure………………………………………………………………...……...Page 30
B. AC & Power Connections……………………………………………………………...………Page 30
C. Sensor Hookup………………………………………………………………………………....Page 31
D. Powering the Meter up……………………………………………………………………...….Page 31
E. Initial settings………………………………………………………………………………...…Page 32
1. Decimal Point Location
Page 32
2. Press Capacity Page 32
3. Triggering the Meter Page 33
a. The Threshold Page 33
b. The Probe Input Page 33
4. The Maximum Channel Number Page 33
5. Track (calibration) Mode Page 34
6. The Calibration Shunt Page 34
7. Peak Mode Page 34
F. Calibration………………………………………………………………………………....……Page 35
1. Pre-calibrated Load Cells
Page 35
2. Calculated Calibrations Page 36
3. Calibration using Reference Load Cells Page 36
G. Computer Interface Hookup……………………………………………………………………Page 37
1. RS422 Interfaces
Page 37
2. RS232 Interfaces Page 37
3. Setup Parameters Page 37
IV. Troubleshooting Information Page 39
A. Using the Output Jack………………………………………………………………………….Page 39
B. Symptoms and Solutions……………………………………………………………………….Page 39
V. Serial Communications Protocol Page 40
A. The Hardware Connection……………………………………………………………………...Page 40
B. Transmission Characteristics…………………………………………………………………...Page 40
C. Record Construction……………………………………………………………………………Page 40
1. The Header
Page 40
2. The Trailer Page 40
3. Data - Computer generated Page 40
a. Data Type Character Page 40
b. Command Character Page 41
c. Entry Data Page 41
d. Data Type Characters Page 41
4. Data - N269 Generated Page 44
a. Record Page 44
b. Mode Construction Page 44
c. High and Low LED Construction Page 45
d. LED Conventions Page 45
e. Numbers Page 46
f. Checksum Calculation Page 46