Micro Tracklight Installation Instructions
Page 2
Mounting Clamp
Mounting clamps are attached
with screws and the Micro
Tracklight fixture is snapped in
place. Recommended spacing is
every 12".
Retainer Clips
Retainer clips are included with Feed
Connectors and Flex Connectors.
These snap onto the fixture to provide
a secure connection.
Feed Connector Assembled
Feed Connector
Feed Connectors bring power to one end of a Tracklight run. Up
to 60 LED Modules can be powered from a single connector.
Mounting Clamp
Retainer Clips snap in
place from above.
Flex Connector
Assembled
Step 3: Insert Feed Connector and End Cap
Step 5: Cut Spacer to size and insert between
LED Modules.
Spacer
Step 3A: Insert Flex Connector
(if required)
Step 6: Install mounting clamps
Do Not Snap Connectors in place
from above. Slide in place.
Retainer
Clips
Retainer Clips
Step 4: Attach Retainer Clips
Do Not Snap End Caps in place
from above. Slide in place.
Lens Replacement
Snoot
Remove Snoot
To replace a lens: Remove the Snoot then gently tap the LED module on a
hard surface and the lens will pop out. Insert new lens and re-insert Snoot.
Remove Lens
Insert New Lens
Re-insert Snoot
