Page 2-2
Document Ref 903647-001 Rev 3
PAS V3 Pump for Fuel Dispensers
Component Technical Manual
PAS type
Motor power
Ø of motor pulley
Ø of pump pulley
PAS 80
1 kW / 1400rpm
95 mm
150 mm
PAS 130
1.5 kW / 2800rpm
71 mm
150 mm
HYDRAULIC PERFORMANCES
The hydraulic performances mentioned below are for a standard installation (one pump on
piping to the tank). The pump has a static lift of 4m, a pipe diameter of 2 inches and a
length of 40m. The fuel temperature is 20°C.
Flow rate:
40 and 80 l/min (motor of 1 kW) or
130 l/min (motor of 1.5 kW)
Pressure:
1.7
≤
P
≤
3.5 bar for PAS V3 80 l/min
2.3
≤
P
≤
3.5 bar for PAS V3 130 l/min
Suction capacity:
vacuum pressure dry pump is 400 mbar,
vacuum pressure wet pump (with oil) is 900 mbar
Pump intake depth
0.5 to 4.5 meters
Air separator
fulfils the EEC regularisation for systems without sight glass
Filters
12 or 25
μ
m paper mesh and 90
μ
m plastic mesh (can be cleaned
and re-used). The filter can easily be replaced without spillage,
and without losing the priming on the suction line due to the foot
valve in the bottom of the filter box.
Liquids
fuels with a viscosity lower than 10
-4
m
2
/s
Minimum inlet vacuum 100mB @ 80 l/min
for correct operation
150mB @ 130 l/min
2
OPERATING DESCRIPTION
2.1
Technical Characteristics
DIMENSIONS
Width x height x length
225 x 450 x 490 mm including motor, filter and mounting
bracket
Weight
37 kg
Suction pipe
Ø 1.5 or 2 inches (40 l/min)
Ø
2 inch (80 and 130 l/min)
Inlet of the filter housing
DN Ø 40/49 mm (1.5”)
Issue C
