The Red Lighting Bolt
should display
whenever the
external power is
connected to the
unit. If not, contact
support at
Tokenworks as this
may indicate a
problem with the
wall charger.
A full charge will
require
approximately 4
hours. The charger
will automatically
switch from full
charge mode to
standby as soon as the battery reaches full charge. The charger will not overcharge
the battery and it is recommended to leave the charger connected.
Battery Charging – Red
Lighting Bolt
Battery at 40% - Yellow
If the Charge LED is Yellow, try turning the wall power on/off. If this does not resolve
the fault condition, it means there is a problem with the battery charger or battery
and technical support is required. DO NOT OPEN THE CASE TO SERVICE THE
BATTERY. Contact
to obtain technical support. Do not use
a wall charger other than that supplied by Tokenworks. Using one with a higher
voltage or reversed polarity will damage the scanner. Using one with a lower voltage
or current rating will not charge the batteries.
IF THE PALM HANDHELD’S BATTERY IS FULLY DEPLETED, THE MAIN SCREEN
WILL NOT TURN ON UNTIL FOR ABOUT FIVE MINUTES. Wait 5 minutes and if
screen does not turn on, try
).
Battery Life
The battery, which powers the License Scanner, is oversized compared to the
capacity of the Palm Z22 handheld. Therefore use the battery level of the Palm Z22
handheld to determine remaining battery life.
IDvisor Hardware Manual
Page 9 of 38
