11
5. PRIME AND DISCHARGE
Sucking up priming water (Automatic)
Refer to “CONTENT 4. STARTING THE ENGINE”.
1.
Press the main switch to turn on the power.
2.
Press the throttle position switch“ ”.
Then the throttle position turns to the suck up
water position“ ”.
3.
Press the start switch “ ” to run the engine.
After starting the engine, the vacuum pump runs to
suck up water.
4. After sucking up water completed, the vacuum
pump stops and the throttle turns to low pressure
position automatically, and then discharge lamp
turns on the light.
The throttle position turns to the low pressure
position after completed of sucking water at
automatic suction water mode just after the power
on.
If the pump could not suck up
water completed in 30 seconds in
the auto priming mode, the
warning lamp lights and the
warning buzzer sounds. Eliminate
the cause referring “Owner’s
manual
of
VE1500A-Ti/
TROUBLESHOOTING”.
Discharge water
status lamp
Priming failure lamp
Low pressure
position
Start switch /
Low pressure throttle
position switch
Main switch
Throttle position
switch (“ ” position)
CAUTION
