9
4. STARTING THE ENGINE
Operating VE1500A-Ti is possible with both of the pump control panel and the remote
control panel.
Connect the remote control panel to the operation panel of pump (VE1500A-Ti).
* VE1500A-Ti pump control panel does not have the engine running status lamp and
discharge water status lamp.
Starting the engine
1.
Press the main switch.
Lamp check will be done for an instant.
(Each lamp lights for about a second.)
2.
Press the throttle position switch “ ” to turn the
throttle position to “ ”. (Then the throttle opening
indicator lamp between low pressure and “ ”
position turn on.)
3.
Press the start switch(/Low pressure throttle
position switch) “ ” until the engine starts. The
starter motor runs while pressing the switch. (The
maximum starter running time should be 3 seconds
at one time.)
Release the start switch “ ” immediately after the
engine starts. The engine running status lamp turns
on.
After the engine starts, the vacuum pump starts
running automatically and runs until sucking up
priming water completed. When sucking up the water
completed, the vacuum pump stops and the throttle
turns to low pressure position automatically, and
discharge water status lamp turns on.
Main switch
Engine running
status lamp
Throttle position
switch (“ ” position)
Start switch /
Low pressure throttle
position switch
Engine running
status lamp
Low pressure position
Discharge water
status lamp
