6
3. USE OF REMOTE CONTROL PANEL
If the throttle position is at lower position (at about Idle position)
than “ ” position, the vacuum pump will not start automatically.
If the starter motor does not operate although the throttle is at the
“ ” position, check if the battery terminals are tightly connected
and the battery is fully charged.
If the engine does not start in five time starting operations,
eliminate the cause of failure, then start the engine.
VE1500A-Ti pump control panel does not have the engine running
status lamp and the discharge water status lamp.
3)
Discharge water
Open the discharge valve(s). Checking pressure
gauges, adjust the discharge pressure by pressing
“ ” or “ ” switch.
While discharging water, wherever the throttle
position is, by pressing the suction water position
switch “ ” or low pressure position switch“ ”, the
throttle position will turn to “ ” or “ ” position.
When opening the discharge valve, turn the throttle to the low
pressure position.
In the case of the remote control panel is connected to the pump
control panel, the throttle dial of the pump does not work.
4)
Stop the engine
Decrease the discharge pressure by pressing the
switch “ ” or “ ” until the throttle turn to low
pressure position.
Close the discharge valve(s).
Press the stop switch to stop the engine. At the
same time, lamps on the panel turn off. (Power
turns off)
Floodlight
When using a floodlight (for VE1500A-Ti), insert the
plug of the floodlight into the outlet.
“Pressure increasing: ”
and
“Pressure decreasing: ”
switch
Discharge water
status lamp
Stop switch
Outlet
NOTE
CAUTION
NOTE
