16
[Rear]
8. DC inlet
Connect the dedicated AD-0910 AC Adapter to this
terminal.
9. Power switch
Press this switch to switch on the power.
To switch off the power, press this switch again.
[Bottom]
10. Lithium-ion battery compartment
Install only a dedicated BP-900A Lithium-Ion
Battery in this compartment.
11. Release key
Press this key to remove the lithium ion battery.
12. Unit address number setting switch
Set the unit address number (001 – 064), taking
care to ensure that the same number is not
duplicated in the system.
If the number [000] is assigned to a unit, the user
of that unit cannot speak. However, the unit can
be used for monitoring.
Set a numeral for the ones place and tens place.
Leave the switch for the hundreds place set to off
whenever using the unit.
Note
This number is factory-preset to [000].
13. Rating nameplate
4. Talk key
When this key is pressed, both the Microphone in-
use indicator (3) and the Speech indicator (7) light,
and the microphone turns on. Pressing this key
again turns off both indicators and the microphone.
5. Power indicator
Lights when the power is switched ON.
This indicator also flashes when the battery level
is low or the unit is outside the communications
service area.
6. Microphone
Use either the TS-923 (Standard) or TS-924 (Long)
dedicated microphone.
7. Speech indicator
Remains lit while the microphone is in use (during
speech). The indicator flashes when the unit is out
of the communications service area.
9
8
Remove the cover on the bottom side of the unit to expose its setting switches.
Cover of the setting switches
11
10
Note
The label describing the setting switches is
shown in the following figure.
12
13
