21
Step 6.
Screw 2 supplied hex bolts loosely to the speaker.
Follow the same installation procedure to the other side.
About 5 – 7 mm (0.2" – 0.28")
Fix the hex bolt loosely leaving about 5 – 7 mm
(0.2" – 0.28") protruding.
Hex bolt M8 x 40
(accessory)
Step 7.
Mount the speaker to the mounting brackets.
Mount the speaker in the way that the Mounting Brackets A and B secured to the wall are inserted
into the slits in the speaker's rear panel.
Loosely fitted hex bolt
Mounting Bracket A
Note
In this event, check to be sure that the
loosely fitted bolts are inserted fully into
the notches in the Mounting Bracket until
they will not go any further.
Mounting Bracket A
Mounting Bracket B
Mount the speaker in the way that
the Mounting Bracket is inserted into
the slits in the speaker's rear panel.
Remove the hole plug on the speaker’s top, then
install the supplied eye bolt instead.
Note
As this eyebolt is for temporarily suspending the
speaker at installation, never use this eyebolt for
permanent installation of the speaker.
When using the supplied eye bolt at the speaker installation
Remove the hole plug.
Eyebolt M10 x 30
(accessory)
