RS-410EC
Wall
surface
OW-101
RS-410EC
Wall
surface
Wall
surface
IW-101
6
Torx Screws
8. Installation
8.2. Installation of the Substation RS-410EC e
8.1. Back Box
Mount the substation to the IW-101 electrical box if mounted in the wall.
Mount the substation to the OW-101 if mounted on the wall.
Note
Tightly seal all panel edges of the OW-101.
Notes
Make sure to seal the edges of both the panel and the box's rear surface when installing the RS-410EC
outdoors or in locations where it gets splashed with water.
Recommended Back Boxes for RS-410EC are either for flush-mounting IW-101 or for surface-mounting
OW-101
Provide a weep hole at the bottom of the mounting box to permit water to drain off.
To insert cable from top- or bottom-side of the box a cable gland must be installed to avoid damages such
as bending or rub through. Consider to use a cable gland that meets the desired water + dust protection.
Drill a hole according to the specifications of the cable gland to be used.
Flush-Mounting:
The front edge of the IW-101 must not be more than 3mm away from the surface of the wall.
Note
Tightly seal all
panel edges of the
RS-410EC
e
e
