9
Video input
Monitor
: BNC plug
Video output terminal
Video output
24 V AC or 12 V DC
Power supply
When operating on 12 V DC, use the external
power supply rated at 12 V DC and over 1.0 A.
6. Connect the camera unit.
Connect the camera unit to the monitor and the power supply referring to the figure below.
Note
If the Video output is not terminated at 75
Ω
, camera images are not properly displayed. Make sure that the
output has been terminated at 75
Ω
at the connected monitor or switcher.
Loosen two sunshade fixing screws.
Turn the sunshade,
then extract it.
Front cover
Turn the front cover in
the direction indicated
by the arrow to remove.
[Removing the sunshade]
[Removing the front cover]
7. ADJUSTMENT
1. After completing camera unit installation and connections, remove both the sunshade and front cover.
2. Connect the camera's monitor output terminal to the monitor.
Note:
The camera will not operate if the monitor output terminal is connected to the camera drive unit.
3. Switch on the power supply. The power is supplied to the camera, permitting the camera images to be
viewed on the monitor.
4. Set each mode setting switch to the position that provides the best picture reproduction.
• If flicker may cause a nuisance, turn the Flickerless switch to ON.
• If the camera images will be too dark, turn the Backlight compensation switch to ON.
Note:
For the details, refer to p. 12, “About mode setting switch.”
