8
3. Install the camera unit to the mounting bracket using the supplied insulation spacers and Bracket mounting
bolt (M8 x 14 hexagon head screw with captive washer).
Note
Be sure to position the insulation spacers between the bracket and bolt, as induction voltage or noise may
be produced at the joints depending on installation conditions. Also, do not remove the insulation washers
attached to the mounting bracket.
Mounting bracket
Bracket mounting bolt
(M8 x 14 hexagon head screw with captive washer)
Insulation spacer
The insulation washers are attached
to the mounting bracket.
4. Connect the connector of the supplied cable with waterproof cap to the camera unit's video output terminal,
then tighten the lock screw of the connector.
Notes
• To meet the waterproof requirements, insert the connector in place until it will not go any further.
• Wrap self-adhesive butyl rubber tape around the coaxial cable joints in order to prevent rain from soaking
in.
Connector
(waterproof type)
Waterproof cap
Video output terminal
Supplied cable
Cable joints
UL1095#22 black/white (non polar)
Connect to the monitor.
Connect to the power supply.
BNC jack
BNC plug
Lock screw
Fit the waterproof cap
(shaded area) into place.
5. Attach the waterproof cap to the camera unit.
Note
If the waterproof cap is not secured to the mounting surface, water or moisture soaks in, causing the
corrosion of the BNC connector. This may cause unit failure. Check to be sure that the waterproof cap is
secured as shown below.
