TMI Products BELAIR-SC8, Руководство пользователя

Страница: 9 / 22

OPERATING THE EXTRACTOR
BEFORE OPERATING:
9
Read the manual carefully and completely before attempting to operate the extractor. Make sure the unit is plugged
into an electrical outlet with the same voltage as shown on the extractor.
1. When plugging in a dual power cord extractor (see below image 9.1); each power cord should be connected on two
separate circuits. When this is accomplished, a green light will turn on, when the “Circuit Test Switch” is pressed on the
switch plate. If the light does not turn on, this indicates that the unit not connected on two separate circuits and there
is a high risk of a circuit blowout.
2. Always thoroughly pre-vacuum the surface to be cleaned. Using an upright vacuum cleaner (or the extractors dry
vacuum with optional dry attachment).
3. Pre-spray the cleaning area with recommended cleaning solution for the best results.
4. Fill solution tank with clean water.
5. Connect both the vacuum hose and solution hose to the proper connections. See image on “Assembly” page.
6. Make sure the drain hose is closed and the recovery tank lid is secured before turning on the vacuum and pump
switches.
Two electric power cords must be
connected to two separate circuits.
Image 9.1
“Circuit test switch” is located next to the green light.
Press the switch button to test the current of the two cords
if the light turns on it means that the cords are on two separate
circuits if the light does not turn on it means that the cords are
on the same circuit.
Detail view of
circuit test switch
B
Image 9.2
Image 9.3