TMG TMG-GSB30, Руководство по эксплуатации продукта

Страница: 6 / 35

UNPACKING AND SETUP
Your snow blower requires some assembly; Save the packing materials and box for future use as a
storage container.
COMPLETELY READ AND UNDERSTAND THE OPERATORS MANUAL BEFORE ATTEMPTING TO
OPERATE THE SNOW BLOWER
.
Assembly
Handlebar and Shift Control Assembly
1. Carriage bolts, curved washers and nylon lock nuts have
been provided in a hardware package. Align the two holes
in the handlebar connector block with the two holes in the
upper and lower handlebars assemblies on the snow blower.
Push carriage bolts through from the outside and secure
with a curved washer and nylon lock nut on the interior in
two places on both sides of the snow blower. Tighten
securely (see Figure 1).
2. Attach the drive wire on the left side of the snow blower
(see Figure 2). Remove the R-clip that connects the drive
wire to the control lever on the handlebars, then slip the
wire off. Attach the other end of the drive wire with the
spring mechanism to the connection ring and reattach the
drive wire to the control lever reinserting the R-clip. After
connecting the wire adjust the tension. The wire should be
taught when connected. (See Control Wire Adjustment,
page 20).
3. Attach the auger wire on the right side of the snow blower
(see Figure 3). Remove the R-clip that connects the auger
wire to the control lever on the handlebars, then slip the
wire off. Attach the other end of the auger wire with the
spring mechanism to the connection and reattach the auger
wire to the control lever reinserting the R-clip. After
connecting the wire adjust the tension. The wire should be
taught when connected.
(See Control Wire Adjustment, page 20).
4. Attach the gear shift rod to the rocker arm on the under
side of the control panel and secure with a cotter pin
(see Figure 4).
5. Attach the other end of the gear shift control rod to the
rocker arm on the rear of the snow blower (see Figure 5).
Pass the attachment bolt on the control rod through the
hole in the rocker arm and secure with a nylon lock nut.
Nylon Lock Nut
Carriage
Bolt
Curved
Washer
Handlebar
Connecting
Block
Fig 1
Drive Wire
Fig 2
R-Clip
Auger Wire
Gear Connector
Bar
Fig 3
Gear Shift
Fig 4
Rocker Arm
Cotter Pin
Gear
Connector
Bar
Control
Rod
Rocker
Arm
Nylon
Lock Nut
Fig 5
www.tmgindustrial.com 06/35 Toll Free:1-877-761-2819