TMG TMG-GSB30, Руководство по эксплуатации продукта

Страница: 17 / 35

Shear Pin Replacement
The auger is attached to the spiral shaft with shear pins
secured with cotter pins. If the auger should strike a
foreign object or ice jam, the snow blower is designed to
shear off those pins (see Figure 20). If the auger will not
rotate, check if the pins have been sheared. When
replacing shear pins, spray an oil lubricant into the shaft
before inserting new pins.
Shave Plate and Skid Shoes
The shave plate and skid shoes on the bottom of the
snow blower are subject to wear. They should be checked
periodically and replaced when necessary.
To remove skid shoes:
1. Remove the four carriage bolts and hex flange nuts which
secure them to the snow blower (see Figure 21).
2. Reassemble new skid shoes with the four carriage bolts
(two on each side) and hex flange nuts.
To remove shave plate:
1. Remove the carriage bolts and hex nuts which attach it
to the snow blower housing (see Figure 21).
2. Reassemble new shave plate, making sure heads of carriage
bolts are to the inside of housing. Tighten securely.
Fig 20
Cotter Pin
Shear Pin
Fig 21
Skid Shoe
Shave Plate
www.tmgindustrial.com 17/35 Toll Free:1-877-761-2819