TMG TMG-AB72, Руководство по эксплуатации продукта

Страница: 20 / 26

W W W . T M G I N D U S T R I A L . C O M P 1 9 / 2 5 T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Stopping the broom
The broom quits moving when the auxiliary control is neutralized. When you are done sweeping for a period
of time, always rest the broom attachment on the brackets designed to support the weight of the broom when
not in use.
To raise the rest brackets, take the weight off the rests by lifting slightly on the broom. Pull the lock pin out of
the rest bracket tube and raise the tube to the position where another hole lines up for the pin. Insert the lock
pin and keeper.
Transporting
Always follow safety rules, carry low to ground and travel slowly.
1. Transport Position: When the broom is in the lowered position, hook the chain in the chain link so
the chain is as short as possible. This will put all the weight of the broom on the transport chain.
2. Be sure to leave enough clearance so the broom does not contact obstacles such as buildings,
trees or fences.
3. Select a safe ground travel speed when transporting from one area to another. When traveling
on roadways, transport in such a way that faster moving vehicles may pass you safely.
4. When traveling over rough or hilly terrain, slow down and use extra care.
5. Read all the safety warnings in the front of the manual.
Unhooking Angle broom
1. Park skid steer loader on a flat, level, solid surface, and lower Angle broom onto the ground.
2. Place transmission in park, set park brake, shut engine off, release operator restraint and
remove switch key.
3. With Angle broom resting on the ground, release all hydraulic system pressures before
disconnecting hydraulic hoses from skid steer loader. See Skid Steer Operator’s Manual for
instructions on how to release skid steer hydraulic system pressures.
4. Disconnect hydraulic hoses from skid steer loader quick couplers. Install dust plugs and couple
hoses together for storage. Store hoses on the Angle broom frame to keep dirt away from the
couplings.
5. Pull lock handles up allowing lock pins to clear bottom slots in hitch plate.