TMG TMG-AB72, Руководство по эксплуатации продукта

Страница: 14 / 26

W W W . T M G I N D U S T R I A L . C O M P 1 3 / 2 5 T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Hydraulic Hose Hook-up
Connect hydraulic hoses to skid steer auxiliary quick couplers.
2 or 3 quick couplers should be connected according to the equipment on the skid steer loader. If only 2
couplers are equipped on the skid steer without the case drain line, then just remove the 3
rd
one and plug the
outlet port accordingly.
DANGER
Hydraulic fluid under high pressure can penetrate skin. Wear protective gloves
and safety glasses or goggles when working with hydraulic systems. Use a piece
of cardboard or wood rather than hands when searching for hydraulic leaks.
If hydraulic fluid is injected into the skin or eyes, it must be treated by
a doctor familiar with this type of injury within a few hours or gangrene
may result. DO NOT DELAY.
IMPORTANT: Collect and dispose all oil spills and leaks in an environmentally safe manner.
IMPORTANT: Hose routing is the responsibility of the owner/operator of the Angle broom. Pinched
and/or stretched hoses are not covered under the warranty.
Section 2: Equipment Hook-up & Unhook
IMPORTANT: Make sure all coupler fittings are clean before connecting them together.
Two high pressure hydraulic outlets are required for the hydraulic motor.
1. Route hydraulic hoses along the most convenient path to access your skid steer loader.
2. Clean quick connect couplers of dirt and then connect couplers to the skid steer couplers.
Make sure quick connect couplers have fully engaged.
If they have not, check the following:
a. Make sure couplers are same size and type.
b. Make sure hydraulic pressure has been released.