12
5
Maintenance
5.1 Cleaning and maintenance
Ensure that the gas valve is completely closed.
Do not carry out any maintenance or cleaning operations until the stove has cooled down completely.
The stove must be cleaned using only and exclusively a dry cloth. Never use pointed or abrasive tools and
always wait until the stove has cooled down. Never clean the stove when it is on and hot
Repairs may only be performed by qualified and certified installers, using original components.
Annually check the status using the appliance and, should you have any doubt, have it checked by a
qualified technician.
Check the state of wear of the flexible hose and replace it, if necessary.
Check the condition of the gas hose periodically for damage. A leak test should be performed before using
the appliance if it hasn't been used for a long time (see section 3.4).
If any damage is found on the gas hose, have it replaced by a qualified technician together with the
pressure regulator.
If necessary, contact a servicing centre.
Cleaning and maintenance operations that require removing any component must be carried out by a
qualified technician.
Any maintenance work carried out during the first 24 months by unauthorised technician, will render the
guarantee null and void.
Note:
Replace the approved pressure regulator EN 16129 and the approved gas hose EN 16436-1 after 10
years from the date of manufacture. The gas tube should have a length of 40 cm.The date of manufacture
is printed on the pressure regulator and on the gas hose.
This operation must be performed by a qualified technician using only original spare parts.
5.2 Faults and repair works
Fault Possible Causes Solutions
Yellow pilot
flame
The gas cylinder is running low.
The nozzle is dirty or clogged.
Replace the cylinder.
Clean with compressed air. Do not use tools.
The flame in
the burner is
yellow
The gas cylinder is running low.
Dirty gas.
The room is very dusty.
When walking near the stove, dust is
sprayed around.
Replace the cylinder.
The flame slowly stabilizes on its own.
The pilot flame
does not come
on.
The cylinder is empty.
See instructions in 4.1
The nozzle is empty or clogged by
dust, insects or insect nests.
No spark
Replace the cylinder.
Follow the instructions in 4.1
Clean with compressed air. Do not use tools.
Contact a specialized technician.
If the appliance is fitted with battery-power
ignition, replace the battery.
Check the connection of the piezo's electrical
wire.
Use a match and ignite through the dedicated
peephole.
The stove
shuts down
during
operation
ODS tripped.
The gas cylinder is empty.
Ventilate the room, wait for a few minutes and
ignite the stove again. If the problem persists, it
means that the room is too small or not
adequately ventilated.
Replace the cylinder.
Leak test
failed
See instructions in 3.4
The gas circuit is damaged.
Follow the instructions in 3.4
Contact your gas dealer.