TMC LI7WM, Руководство пользователя

Страница: 96 / 97

Chapter 11 LI7WM and the Databook Case
96 LI7WM User’s Manual
3-13. Screw the HDD plastic siding onto the right side of the hard
disk drive.
3-14. Install the hard disk drive and CD -ROM into the front panel
unit.
3-15. Install the CPU.
3-16. Install the front panel unit back to the case.
3-17. Connect the cables for FDD, HDD, CD-ROM, and mini
cables for HDD LED, power LED, LAN LED and reset switch.
3-18. Screw the front panel section back to the case. Refer to 2-1.
3-19. Return the top cover with a gap of 1cm (
Do not exceed
1cm. ) between it and the front panel edge. Refer to 1-3.
3-20. Press down the top cover and push it to the front until the
two clips on the sides of the cover lock in place. Refer to 1-2.
3-22. Stick the four base supports supplied to the designated
points at the bottom side of the case.
4. Installing an additional PCI expansion card.
4-1. Remove the top cover. Refer to sections 1-1 ~ 1-4.
4-2. Remove the left-side screw at the back of the case and the
small plate. And then remove either one of the expansion slot
cover.
4-3. Install the PCI expansion card.
4-4. Return the left-side plate and its screw.
4-5. Screw the PCI card into place
3-11 Attach the
plastic
siding
to this
FDD front side
3-11 Attach the
plastic
siding
to this
HDD front side
Back Panel
4-2. Remove this
screw and
the
small 4-2. Remove either one
of the
expansion
slot cover.