Over Temperature Protection
The smart fans will start to work when the lights are on full, or the temperature of the light is over 38°C
(100°F) and will stop when it cools to around 34°C (93°F). If the unit gets too hot, at around 60°C
(140°F), the light will shut down and the display will show
Blue LED Trim Operation
To control the blue LED trim, point the remote control at the infrared sensor on the light unit at the
opposite end from the cable entry.
Press and to change the brightness of the blue LED trim up and down.
Press to turn it off and to turn it back on again.
If you press the trim will automatically dim and brighten to create a pulsing effect.
Troubleshooting
The light does not work
1. Check that it is connected to the power. If not, connect it.
2. Check if the light is in slave mode or off (display showing or ). If so press to return to run mode.
3. Check if the brightness is set to ‘0’. Press or or or or to adjust the brightness level.
4. Check that the light is not supposed to be off according to your set program. Refer to page 7 to adjust
the program.
The light is always on
1. Check if the total photoperiod is over 24 hours in duration. Refer to page 7 to adjust the program.
2. Check the time is set correctly. Press and or to set the time.
The screen displays
1. Check if the top of the unit and fans are blocked or covered. If they are, remove dust/debris to ensure
good air flow.
2. Check if the fans are operating. If not then refer to Tropical Marine Centre or your local dealer for
replacement fans.
The remote control does not work
1. Check if the light is in slave mode or off (display showing or ). If so press to return to run mode.
2. Check that the remote control is pointing to the correct infrared sensor on the light unit for the
operation you are trying to perform. Refer to page 6.
3. Check the battery. This can easily be replaced with a CR2025 coin cell.
The light is flashing
1. Ensure that the light isn’t in storm or demo mode. Press to return to run mode.
OFF
RUN
RUN
RUN
RUN
COLOUR
DEMO
Err
Err
In
OFF
In
OFF
9
V2iLumenAir 900-1200 instructions multilingual v2-2014 REWORKED FINAL_Layout 1 25/07/2014 12:28 Page 11
