ProPlex SceneSwitch 8 user manual version 1.9 11 June 2021
5
S
AFETY
I
NSTRUCTIONS
•
Keep this User Guide for future reference. If unit is sold to another user, make sure they also
receive this instruction booklet.
•
Ensure the unit is connected to proper voltage, and that line voltage is not higher than that
stated on the device.
•
Make sure there are no flammable materials close to the unit while operating.
•
Always disconnect from the power source before servicing or fuse replacement. Always use the
fuse specified in this manual..
•
Always use a safety cable when hanging unit overhead.
•
Maximum ambient temperature (Ta) is 40°C (104°F). Do not operate unit at temperatures above
this rating.
•
In the event of a serious operating problem, stop using the unit immediately. Repairs must be
carried out by trained, authroized personnel. Conact the nearest authorized technical
assistance center. Only OEM spare parts should be used.
•
Do not connect the device to a dimmer pack.
•
Make sure power cord is never crimped or damaged.
•
Never disconnect power cord by pulling or tugging on the cord.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service, please
contact your distributor.
F
USE
R
EPLACEMENT
The SceneSwitch uses a 1.0A, 250V barrel fuse, 5x20mm (0.2x0.8 in.).
To replace fuse:
1.
With a screwdriver turn the fuse cap counter-clockwise to remove fuse cap with fuse.
2.
Replace fuse attached to fuse cap.
3.
Reinsert fuse cap with new fuse and tighten clockwise
Please read these instructions carefully. This user guide
contains important information about the installation, usage
and maintenance of this product.
Disconnect the power cord before replacing a
fuse and always replace with the appropriate
fuse.
