TMB DATAPLEX DPNODE663PTB, Руководство пользователя

Страница: 13 / 28

DATAPLEX DEVICES—Node 1x6 User Manual v1.1—25112020
13
RDM / DMX SERIAL LINK
NODE 1
X
6 PTB
PTB (Pluggable Terminal Block) connectors require bare wire installation into removable, screw-type terminal
connectors with tension sleeves. Depending on the application, cables can be unterminated on both ends, or have
a connector on one end to interface with other equipment (e.g. 5-Pin XLR). Each output connection point follows
the same diagram for common, data positive and data negative conductors.
1—Strip the bare-end wire insulation back 7mm or roughly ¼ inch from cable end.
2—Insert bare wires into connector per the diagram below. Turn each connector set screw with a small flathead
screwdriver until tension spring is fully tightened onto the wire.
3—Connect the terminated PTB cables to the DMX ports A-F and link to fixtures, Opto-Splitters or other
equipment as necessary. Each port can be configured either as DMX output or input via the Web Interface or
ProPlex Software.
4—To receive an incoming Art-Net or sACN stream, connect an Ethernet cable from your network into the
Ethernet port on the back of the Node 1x6.