TMB DATAPLEX DPNODE663PTB, Руководство пользователя

Страница: 14 / 28

DATAPLEX DEVICES—Node 1x6 User Manual v1.1—25112020
14
RDM / DMX SERIAL LINK
NODE 1
X
6 IDC
IDC (Insulation-Displacement Contact) connectors are designed to decrease installation time as they do not
require cable insulation stripping. Instead the connection is formed by forcing a sharp blade through the cable,
which pierces through the insulation and into the conductor core. Depending on the application, cables can be
unterminated on both ends, or have a connector on one end to interface with other equipment (e.g. 5-Pin XLR).
Each output connection point follows the same diagram for common, data positive and data negative conductors.
1—Insert a small screwdriver into each of the 3 orange tabs on the IDC connector. Using gentle upwards pressure,
push open the tabs to reveal the cable insertion point.
2—Fully insert unstripped wires into connector per the diagram below and push down the orange tabs. Once fully
depressed, the blade should bite down on the cable and pierce through the insulation.
3—Ports A-F can be linked to fixtures, Opto-Splitters or other equipment as necessary. Each port can be
configured either as DMX output or input via the Web Interface or ProPlex Software.
4—To receive an incoming Art-Net or sACN stream, connect an Ethernet cable from your network into the
Ethernet port on the back of the Node 1x6.