TM TM63 LED, Руководство пользователя, Страница: 9 / 34

ENGLISH ENGLISH
08
Installation of this dishwasher is to be performed by authorized service and following the instructions
that the country's legislation.
Then follow the steps below for proper installation:
1.
Check the water pressure of the network: it must be at least 2.5 bar and maximum 6 bar. Remember that
water temperature must be between 5 ° C and 40 ° C.
2. Before the installation, close the water tap usually the same place you are going to install and open a
faucet to depressurize it.
3. Choose an installation location near an electrical outlet of 220V - 50Hz
4.
Check the correct status of the tubes.
5. Remove the cap covering the valve and then the lid of your softener. Remove the by-pass valve and the
transformer:
06. WATER SOFTENER INSTALLATION
1 2
3
Remove the clips
on the threads.
Remove the threads
Input / Output.
Place the boards
both threads.
Place the threads
in the valve.
Insert the By-pass
in the valve.
Re-placing
the clamps
1. Input connection
2. Outlet connection
3. Drain connection
1. Input connection
2. Outlet connection
1 2
2 1
6.
Connect the inlet and outlet to the "By-Pass".
7. Follow these steps to put the by-pass valve:
8.
Check the volumetric counter sensor is connected properly.
SENSOR