TLV J3X, Инструкция по эксплуатации

Страница: 17 / 24

172-65132MA-07 (JX Series) 16 Feb 2022
16
Part
J(F)3X
J(F)5X
J7.2X
J7X
J7.5X
J8X
During Disassembly During Reassembly
Screen
Holder
Retainer 11
– – 
Lift straight up and out Insert into the body straight
Screen
Holder 10
–  
Lift straight up and out Insert into body, making sure the
rounded side is on top
Float 4
  
Remove, being careful
not to scratch the
polished surface Insert, being careful not to scratch
or misshape
Orifice
Holder Plug
7
  
Remove with a socket
wrench Coat threads with anti-seize;
consult the table of tightening
torques and tighten to the proper
torque
Orifice
Holder
Gasket 8
  
Remove the gasket and
clean sealing surfaces Replace with a new gasket if
damaged
Orifice 5
  
Push out from inside
the body toward the
orifice plug holder Insert with the proper orientation
(figure E): insert from the outside
of the body, pushing in until it
contacts the stopper inside; if the
condensate discharge hole is
pointing sideways, extended use
may result in a hole in the body
Orifice
O-Ring 6
  
Remove, being careful
not to damage the
rubber orifice O-ring Coat with heat-resistant grease;
use a new orifice O-ring whenever
replacing the orifice
Figure D
Figure E
Arrow
Tab
Flat surface facing
straight up
Discharge hole