TLS-BocaSystems Lemur-X, Руководство оператора

Страница: 32 / 55

31
When the Lemur-Z leaves the factory it is configured for us with receipt rolled stock (stock with no black
timing mark). If you are using the printer with stock that has a black timing mark then it will need to be
taken out of paper mode. See
Appendix C
– DOWNLOADING SOFTWARE COMMANDS
to download the
appropriate software command.

<pmd> this will configured the printer for use with ticket stock with a black timing mark.

<pme> this will configured the printer for use with receipt stock without a black timing mark.
The printer will reset upon receipt of one of the two above mentioned software commands.
The below commands are available for the Lemur-Z configuration ONLY.
<kec#> Kiosk eject count. The default value is 80. This is the number of steps taken to move the ticket to eject point
where it will retracted if not removed within the timeout period. Usually, this number should not be modified but if the
ticket does not retract properly then it may need to be adjusted to ensure proper retraction.
<ket#> Kiosk eject timeout command. The default value is 3 seconds.
<kem#>
Kiosk eject mode configuration command. Each bit represents a different configuration option.
BIT0 LOOP BIT -> clear - loop ticket inside, set - no loop
BIT1 NAK BIT -> clear - no NAK, set - NAK on trashed ticket.
BIT2 MOTOR BIT -> clear - small platen motor, set - larger platen motor (For factory use only)
BIT3 EJECT BIT -> clear - present ticket to be pulled out, set - eject ticket immediately
LOOP
= Loop ticket inside = no loop
NAK = no NAK = NAK on trashed ticket
MOTOR = small platen motor = large platen motor *
EJECT =
present ticket to be pulled out
= eject ticket immediately
*Printer would need optional larger stepper motor
LOOP
Nak
Motor
Eject
Value 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
The default value is zero. This configures the printer as follows: Internal ticket loop, no NAK on trashed ticket, small
platen motor and ticket is presented to be pulled out by
customer. Note: if ticket is not removed within the ‘kiosk eject
timeout’ period it will be retracted into the trash bin (trashed).
As an example, if you wanted the ticket to not loop inside before ejecting immediately you would send
<kem9>
command to the printer.
Failsafe mode for both Lemur-X and Lemur-Z:
To enter Failsafe mode, hold the ‘CHOICE’ button in for at least 5 seconds while powering on the printer. If the USB port
is connected you should hear the normal USB port detected sound on the computer. Failsafe mode is for cases where we
need to reconfigure the printer before it proceeds to initializing. Note: the Ethernet interface does not work in this mode.
Click here to return to >
Table of Contents