TLS-BocaSystems Lemur-X, Руководство оператора

Страница: 31 / 55

30
APPENDIX C
– DOWNLOADING SOFTWARE COMMANDS
Menu setting changes may be done by utilizing the software commands listed below. This is best done using
configure and test program for Windows (see Appendix B ) or our customer program for MAC (see APPLE/ MAC
BASED SYSTEM ) .
If needed, the printer may be defaulted back to its originally factory settings as follows. With the printer
powered off hold down the TEST button and then power up the printer. Keep the TEST button held down for
10 seconds and release (the printer will reset at this time).
Once the customer program is running and is connected to the printer, c
lick on the “Send Text” button.
For the
MAC customer program under the Select Printer Operation choose “Send Text Commands”.
Once the Text Data box comes up you type the text command in the Data input box. Then click on the OK
button and the text data will be sent to the printer.
You may click on the HELP button at any time to open up the help window.
Lemur Kiosk Printer Information:
Lemur-Z

Eject mechanism (Presenter)

Can be run in Ticket mode (will auto load and measure ticket size)

Can be run in Paper mode (will auto load paper to top of form)

Can be run in Receipt mode (will auto load paper to top of form). Note:
there is a minimum ticket length of 2.75”
needed to reach the eject mechanism. Therefore, in receipt mode if the ticket will be shorter than 2.75” an
<RC0,600> followed by a blank character should be included in the text.

Lemur-X

Designed to work with thicker stock as compared to the Lemur-Z

No Eject mechanism (No Presenter)

Can be run in Ticket mode (will auto load and measure ticket size)

Can be run in Paper mode (must be manually loaded to top of form)

Can be run in Receipt mode (will auto load ~ 2.5
” past top of form and then cut)
The following command is available for both the Lemur-Z and Lemur-ZX printers:
<km#> Kiosk Mode (This command is set at the factory and normally should not be changed.

0 - No

1 - Lemur-Z (uses kiosk black mark position)

2 - Lemur-X (uses kiosk black mark position)

3 - Lemur-XBM (same as Lemur-X except uses ticket stock with black mark at the leading edge of ticket)
Note: The
kiosk black
mark is at 1.5” for both the Lemur-X and Lemur-Z (
www.bocasystems.com/ticket_specs10.html ).