Caution
: After installation of camera, please take out vinyl on camera lens.
Remove the back frame of camera unit using the screw driver.
Mount the camera back frame to wall with tamperproof screw 2EA
Connect a lead wire with terminal in line with connecting system.
After connecting on the back of the camera unit, fix the camera firmly into
the attached back frame and fasten with machine screw 1EA (M3
12)
After mounting the camera unit, cover the screw hole with the caps supplied.
CALL
83.5mm
(3.5/16")
For wall surface mounting,
remove the indicated part
to pass cable through
top or bottom.
Tapping screw
single-gang box
BACK FRAME
CAMERA
PLATE
MACHINE
SCREW
(M3X12)
MAIN UNIT
WALL
CALL
When main unit is inserted
into single-gang box,
be sure that the 2 jaws
must be put in
signal-gang box firstly
3-4. Installing the outdoor unit
1. Following the advice in the ‘Recommended installation heights’ diagram and the section
‘Important installation advice’, decide on the best location for the outdoor unit. Now connect the
4-wire cable to the outdoor unit as described earlier in ‘Cable connection’.
4wires from camera
Tapping Screw
(4 X 30)
AC Adaptor
AC Plug
Fixing Hole
Wall-Bracket
W
ALL
(A)
DOOR OPEN
INTERPHONE
MONITOR
3-3. Installing the indoor unit
1. Connect the 4-wire cable to the unit as described in ‘Cable connection’. Then follow the advice
given in section 2 & 3.
Important installation precautions: Decide on a convenient location for the indoor unit.
2. If the unit is to be wall-mounted, fix the wall-mounting bracket securely to the wall using spacers
and screws provided. Ensure that the bracket is flat against the wall and level. If wall mounting is
not required simply position the unit on a suitable table or desktop.
3. With the wall bracket securely fixed to the wall, place the indoor unit firmly against the bracket and
line up the clips(A) on the wall bracket with the wall mounting slots(A) on the rear of the indoor
unit.
4. When you are sure that the wall bracket clips are correctly aligned with the wall mounting slots on
the rear of the indoor unit, press down on the indoor unit so that it slides easily on to the wall
bracket hooks.
5. Ensure that the unit is correctly and securely positioned on the wall bracket. Now run the
connecting cable to the point where the outdoor unit is to be sited, ensuring that cable runs tidily,
either in a channel in the wall or floor or fastened neatly onto the surface of walls, skirting boards
etc.
