TLA SSP-1, Руководство пользователя

Страница: 10 / 19

Page | 10
TrueLifeAudio
IEC Power Inlets& Fuse Holders
The PSU-1 Power Supply Unit is a monaural design too so it has two IEC plugs and you need two grounded IEC
power cables of your choice, in order to power both channels. Check and make sure the power buttons is switched off
and the Logo lights on both units is off, then attach two grounded IEC power cable jacks to the two IEC plugs.
Connecting output cables
Your SSP-1 Control Preamplifier has two pairs of OUTPUT connectors on the rear panel
, a pair
XLR Unbalanced
Outputs and a pair of RCA Unbalanced Outputs, so can accommodate both types of interconnect cables.
You have to connect the right and left channel of your SSP-1 Control Preamplifier to the inputs of your power
amplifier accordingly.
Good quality connectors provide added assurance against signal degradation due to contact corrosion. Regardless of
cable or connector material, verify that the contacts are clean, and that the plug‟s outer shield is tight on the jack, to
avoid hum.
Connecting input cables
Three pairs of INPUT RCA connectors and one pair of INPUT XLR connectors are located on the far right side of the
rear panel of the preamplifier.
Shielded RCA (Unbalanced) or XLR (Unbalanced) type cables should be used to connect different sources to the four
line level inputs.
How to avoid noise problems
Τhe
SSP-1 Control Preamplifier contains circuitry that might be sensitive to magnetic fields and RF signals. The unit
should be placed well away from transformers, etc. Care should also be taken in routing all signal cables. They should
not run parallel to speaker cables or AC cables mains. Keep cables as short as possible. For minimum hum, the
control preamplifier unit should be placed away from the power supply unit.
How to Avoid Damages
A good operating practice is to turn off all equipment before any connections or disconnections are made.
Do not, under any circumstances, connect or disconnect equipment when power is turned on. If you insist on
connecting or disconnecting while power is turned on, you should be aware that the design of the RCA plug generates
a large transient when inserting the plug.