-3-
-2-
or down, but also can be adjusted to ex. 30% or 50%. And when manual controlled by
push button, the controller also can memorize the position and send the new shutter
position to its controller (ex. IP-Gateway).
TM
Adding to Z-Wave Network
In the front casing, there is an on/off button with LED indicator which is used to stop
motor stalling or carry out inclusion, exclusion, reset or association.When first
power is applied, its LED flashes on and off alternately and repeatedly at 2-second
intervals. It implies that it has not been assigned a node ID and can not work with
Z-Wave enabled devices.
The table below lists an operation summary of basic Z-Wave functions. Please refer
TM
to the instructions for your Z-Wave certificated primary controller to access the
setup function, and to include/exclude/associate devices.
function
Description
LED Indication
No node ID
Add
Remove
The Z-Wave controller does not
allocate a node ID to the switch.
1.Have Z-Wave controller entered
inclusion mode.
2. Pressing On/Off button three times
within 1.5 seconds will enter inclusion
mode.
1. Have Z-Wave controller entered
exclusion mode.
2. Pressing On/Off button three times
within 1.5 seconds will enter exclusion
mode.
1-second on,1-second off
Press for on
Release for off
Press for on
Release for off
function
Description
LED Indication
Reset
Association
Node ID has been excluded.
1. Pressing On/off button three times
within 1.5 seconds will enter inclusion
mode.
2. Within 5 second, press On/Off
button again for 1 seconds until LED
is off.
3. IDs are excluded.
1. Have Z-Wave controller entered
associaton mode.
Or Pressing On/Off button three
times within 1.5 seconds will enter
association mode
2. There is only one group for the switch
(it can associate max five devices)
LED twinkle once
Press for on
Release for off
LED twinkle once
Press for on
Release for off
Including a node ID allocated by Z-Wave controller means Add. Excluding a
node ID allocated by Z-Wave controller means Remove.
Failed or success in including/excluding the node ID can be viewed from the
Z-Wave controller.
Association: it can be associated by Z-Wave devices with association
Use the"Reset" procedure only in the event that the network primary controller
is missing or otherwise inoperable
Содержание TZ75
Страница 6: ......
