FITTING INSTRUCTIONS
Product:
T13 Outback Deluxe Frontal Protection System
Vehicle:
Holden Colorado 2016+
Part No.
070SB13L32R
For product warranty, please refer to our website, www.tjm.com.au
File: F-13409
Page 23 of 28
28/03/2017
81.
Record the position and orientation of each
sensor, then remove them from the OE
housings.
82.
Remove the parking sensor harness from the
bumper.
83.
Remove the OE rubber isolating ring from the
parking sensors and replace with the isolating
rings supplied in the fitting kit.
84.
Press out the blanking from the front of the
parking sensor housing and insert the parking
sensor.
85.
Secure the parking sensor retaining plate to
the parking sensor housing using the supplied
8g x 25mm pan head screws.
86.
Apply the supplied 1.2mm (thicker) double
sided sticker to the front face of the parking
sensor housing.
NOTE WHEN AFFIXING THE CENTRE
PARKING SENSORS TO THE FPS:
Housings and sensors must be oriented as
shown, with the top parking sensor housing
peg closest to the T-Slot and connector
facing towards the FPS mount.
If a winch is fitted, it may also be
necessary to fit parking sensor shields as
described in 076SKITA32R Instructions.
RHS SHOWN
