6
RL60-2 /
Manual
Titgemeyer / 10342EN1121 / 1
English
4. Occupational health and safety
The following instructions and directives
apply to the riveting tool described in
these operating instructions and to all
user groups.
In addition to the general instructions
in this chapter that concerns the entire
document and all procedures of using
the riveting system, some parts of this
document may contain additional safety
instructions which then specifically rela
-
te to the described matter.
5. Safety measures
Basic safety measures to avoid damages
and injuries.
Improper use of the tool may lead to
an injury or damage of property. To
avoid damages, always adhere to the
corresponding safety instructions of the
safety measure. Only qualified staff are
authorized to perform maintenance and
repairs of the tool.
6. Special safety advice
The riveting tool is exclusively designed
for setting blind rivets. The Customer
bears individual responsibility for each
and every change of the riveting tool!
ATTENTION!
— Use the tool only after reading and un-
derstanding the operating instructions.
— Do not operate with the tool if you are
ill, under the influence of drugs, alcohol.
— Do not use the tool when it is incom-
plete and when it has visible mecha-
nical defects.
— Never aim the riveting tool at people
and do not rivet without material.
— Use the riveting tool only at working
temperature ranging from 5°C to 45°C.
— Never get over the maximum limit of
input air-pressure of 7 bar
— In case the provided air pressure
exceeds the max of 7 bar, use appro-
priate equipment to reduce it.
—
Use only fittings and hoses for an
approved operating pressure of 10
bar in pneumatics.
— When adjusting or replacing com-
ponents, always disconnect the tool
from the compressed air supply
— For the used rivet diameter, use the
suitable nosepiece (5) accordingly.
— Always use personal protective equip-
ment.
— Tool not in current use must not be con-
nected to the compressed air supply
— Use the tool only for riveting
— Do not use the tool without assem-
bled nosecap (6).
— The riveting tool must not be carried
or lifted by the air hose
— Make sure, the suction system is not
activated, while disassembling the
mandrel collector (2), for emptying.
