POLE PRUNER 750W TTB426GDO
2). SAW CHAIN TENSIONING
Always check the saw chain tension before use, after
the first cuts and regularly during use, approx. every 5
cuts. Upon initial operation, new chains can lengthen
considerably. This is normal during the break-in period and
the interval between future adjustments will lengthen quickly.
e). Mount the guide bar and saw chain assembly over the
sprocket and align the slot in the guide bar with the rail.
Push the guide bar to the left towards the sprocket. Make
sure the tension pin is inserted into the lower hole (A) on the
guide bar. (See Fig.4)
f). Fit the side cover and cover insert back, tighten the screw
using the Allen key. (See Fig.5)
g). The saw chain is not yet tensioned. Tension the chain as
described under “SAW CHAIN TENSIONING”. After running
the chain saw for approx. 1 hour, adjust the chain tension.
Fig. 4
Fig. 5
WARNING!
Unplug from power source before
adjusting saw chain tension.
WARNING!
Cutting edges on saw chain are sharp.
Always wear protective gloves when handling chain.
WARNING!
Always maintain proper chain tension.
A loose chain will increase the risk of kickback.
A loose chain may jump out of guide bar groove. This may
injure operator and damage the chain.
A loose chain will cause rapid wear to chain, chain bar, and
sprocket.
WARNING!
Tensioning the chain too tightly will
overload the motor and cause damage, insufficient
tension can provoke chain derailing, whereas a correctly
tightened chain provides the best cutting characteristics and
prolonged work life. The chain life depends mainly upon
sufficient lubrication and correct tensioning.
Содержание TTB426GDO
Страница 27: ...POLE PRUNER 750W TTB426GDO...
Страница 30: ......
Страница 31: ...POLE PRUNER 750W TTB426GDO...
Страница 32: ...8458 4308012 011...