Sensor Client Clusters
:
Cluster Name
Cluster ID
Cluster Attributes
OTA
0x0019
N/A
Battery Information
:
Please make sure batteries are disposed of in accordance with EC Directive 2006/66/EC, amended by EU Directive
2008/12/EC or in line with your territory battery disposal guidelines.
It is important not to short-circuit, crush, disassemble, heat above 100°C, incinerate, or expose the batteries to water. Do
not solder directly to the cell. The recommended batteries for the Titan Products wireless sensors are 3.7V 2600mAH AA
size lithium-thionyl chloride. These are not rechargeable.
All batteries should be stored in a clean, cool, dry and ventilated area. When installing or replacing a battery please make
sure the polarity is correct. Batteries are not covered by the Titan Products product warranty.
FCC Information
:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Conditions of Use
:
•
The sensor is to be firmly fixed to the ventilation duct work using the sensor’s external fixing holes. See Fig 3.0.
•
The sensor should be mounted in a location representative to the duct air to be measured and must be situated away
from and bends or junctions as well as any turbulent air movement patterns within the duct work.
•
The sensor is designed to monitor air temperature within a duct work and should not be exposed to any harmful or
corrosive gases within the duct work.
•
Ensure the sensor is installed in the correct orientation and location. See Fig 2.0.
•
The sensor should not be used outside of its operating temperature range of 0 to 50°C.
•
The sensor should not be used outside of its operating humidity range of 5-80% RH (non-condensing).
•
The sensor is for use within internal duct works only.
•
The sensor enclosure is rated at IP41 and should be used in environments where suitable. The sensor is not
suitable for environments where contaminants, moisture or corrosive substances can cause harm or impact on the
performance of the sensor.
•
The stated battery life is estimated based on Titan Products’ recommended minimum, maximum, delta change
reporting and polling settings.
•
Min reporting of 60 seconds
•
Max reporting of 300 seconds
•
Change of value of 0.5°C
•
Polling set to 60 seconds
•
It is the responsibility of the buyer/installer to ensure the sensor is suitable for integration in to their ambient temperature
monitoring system.
•
The sensor is designed for the monitoring and transmission of ambient temperature conditions only.
•
The receiving Zigbee Wireless controller should be set up to alarm if out of range conditions are transmitted by the sensor.
•
Battery status clusters are available in the sensor device. These clusters should be used in a maintenance program to monitor
when the battery needs replacing.
•
It is the installer’s responsibility to ensure a site survey is completed ensuring the sensor location is suitable for the environment
to allow consistent and stable transmissions between the sensor(s) and receiving device. Repeaters may be required.
•
It is the customer’s/installer’s responsibility to ensure the sensor standards are acceptable for the country or state the device is
being installed within.
Zigbee HA1.2 Wireless Duct Temperature Sensor (TPZDS/HA1.2)
