Please ensure:
•
Sensors are mounted with a minimum of 1m downstream of any heating or cooling source within the duct work.
•
Sensors are mounted a minimum of 1m away from any bends or air turbulence within the duct work.
•
Probe ventilation holes are aligned with the air flow direction.
•
External fixing holes are used - DO NOT drill enclosure.
Side view
Front view
External fixing holes
Ventilation Holes - to be aligned
with Air Flow direction
Fig 3.0
Commissioning LED indication
:
Do not insert the sensor battery until the device is ready for commissioning and the WAC is powered up and available to
pair with the wireless sensors.
When the sensor is initially powered up with the battery inserted it will be un-paired and the LED will flash every second.
This shows that the sensor is searching for an available network.
Once the sensor has joined the network the LED will remain OFF at all times.
LED Indication
Sensor Status
LED flashing every 1 second
Sensor is not paired and is searching for a network.
LED off
Device is paired.
Factory Reset
: (It is possible to restore the device to its factory settings). Also see LED timing below.
Airflow
direction
Fig 2.0
Installation and Dimensions:
Zigbee HA1.2 Wireless Duct Temperature Sensor (TPZDS/HA1.2)
