Titan SF210JSL, Инструкция по безопасности и эксплуатации, Страница: 20 / 28

Note:
The saw dust may “lock” the laser beam,
clean the laser generator periodically.
WARNING: Never stare directly into the
laser beam and never point the beam at
anybody.
11. ADjUSTING THE LASER CUTTING
GUIDE
The laser generator has been factory calibrated. It
requires re-calibration only when the laser beam
deviates from the cut line. see Fig22.
WARNING: Keep your hands/fingers
out of cutting blade area. Never switch
on the mitre saw when adjusting the laser
generator and holder.
To correct the laser beam error, follow the steps
below:
1. Turn the laser On/Off switch to the On position
marked.
2. The beam that is projected should be parallel
with the partial cut in the piece of scrap wood
Fig23.
3. If it is not parallel with the partial cut, loosen
the laser generator retaining screw see Fig24
and rotate the laser generator until the beam is
parallel with the partial cut.
4. Retighten the laser generator retaining screw.
5. You can also adjust the laser beam laterally
by loosening the two screws holding the laser
generator, move the laser generator to the
required position and retighten the screw.
MAINTENANCE
WARNING: Before making any
adjustment, maintenance to the saw,
make sure that it is disconnected from
mains supply.
When all the adjustments, settings or
maintenance have been done, make sure
that all keys and wrenches have been
removed and that all screws, bolts and
other fittings are securely tightened.
1. PRECISION SETTING OF ANGLES
While the machine has been factory set, it is
advisable that the 0
O
setting of the rotary table
Fig 23
Fig 22
Fig 24
Laser module
retaining screw
Fig 25
Straight
guide
clamp
screw