Titan SF210JSL, Инструкция по безопасности и эксплуатации, Страница: 15 / 28

8
”
Laser sLiding Compound mitre saw sF210JsL
3. Make sure that the vertical clamp securing
screws are tightened. See Fig5.
Stop block (Fig6a and 6b)
The stop block is included with the table extensions
and is useful as a stop for making repetitive cuts
to the same length. It can be installed on either
side of the saw base:
1. Fit the stop block over the table extension rod.
2. Insert the ends of extension rod into the holes in
either side of the base, adjust the block to desired
length and tighten the stop block securing screw.
3. Secure the extension rod by tightening the
clamp screw on the front face of base.
4. Make a test cut in scrap material and measure
the length of the workpiece.
5. Make any necessary adjustments.
Mounting bolt
Before use, the saw should be fixed to a firm, level
surface with the 4 mounting bolts (supplied).
Four holes are provided in the base of the saw
to enable it to be fixed to a bench, or other
supporting surface. See Fig7.
If the saw is to be moved frequently, it should
be mounted on a plywood base, minimum
20mm(3/4) thick, which can then be clamped to a
supporting surface using G clamps.
To mount the saw, proceed as follows:
• Locate and mark where the saw is to be
mounted.
• Drill four 8mm diameter holes through the
surface.
• Place the sliding mitre saw on the surface
aligning holes in base with holes drilled in the
surface. Install bolts, washers and hex nuts. See
Fig7.
OPERATION INSTRUCTIONS
WARNING: Use clamping position that
does not interfere with operation.
before switching on, lower saw head to
make sure clamp clears guard and saw head
assembly.
Fig 5
Fig 6a
Fig 6b
Fig 7
Bolt
4xMounting
hole
Washer
Nut